The effect of age on the attachment ability of stick insects (Phasmatodea)

• Marie Grote,
• Stanislav N. Gorb and
• Thies H. Büscher

Beilstein J. Nanotechnol. 2024, 15, 867–883, doi:10.3762/bjnano.15.72

• ]. Roughness dependence of attachment performance decay The performance of insect attachment pads recorded on a smooth surface is usually higher than on microrough surfaces [14], and asperity sizes around 0.3–1.0 µm have been confirmed to be a critical roughness at which adhesion is the lowest [33][57][58][59

Insect attachment on waxy plant surfaces: the effect of pad contamination by different waxes

• Elena V. Gorb and
• Stanislav N. Gorb

Beilstein J. Nanotechnol. 2024, 15, 385–395, doi:10.3762/bjnano.15.35

• contamination of insect adhesive pads with three-dimensional epicuticular waxes of different plant species contributes to the reduction of insect attachment. We measured traction forces of tethered Chrysolina fastuosa male beetles having hairy adhesive pads on nine wax-bearing plant surfaces differing in both

• (number per unit area) influence insect attachment [11][12]. As an explanation for reduced insect adhesion on waxy plant surfaces, several contributing mechanisms have been previously suggested, such as (1) specific micro/nanoroughness created by wax projections (roughness hypothesis), (2) contamination

• ) (Coleoptera, Coccinellidae) proved the primary effect of absorption of the insect pad secretion by the porous substrate on the insect attachment force [25]. According to the contamination hypothesis, wax projections can completely or partially detach from the plant surface and adhere to the insect pads

Biomimetics on the micro- and nanoscale – The 25th anniversary of the lotus effect

• Matthias Mail,
• Kerstin Koch,
• Thomas Speck,
• William M. Megill and
• Stanislav N. Gorb

Beilstein J. Nanotechnol. 2023, 14, 850–856, doi:10.3762/bjnano.14.69

• and insect attachment on leaf surfaces of Schismatoglottis calyptrata (Araceae)” a study of the development of cuticular ridges on the adaxial leaf surfaces during leaf ontogeny of the tropical Araceae S. calyptrata. The structure of these microscopic ridges helps plants to defend themselves against

Hierachical epicuticular wax coverage on leaves of Deschampsia antarctica as a possible adaptation to severe environmental conditions

• Elena V. Gorb,
• Iryna A. Kozeretska and
• Stanislav N. Gorb

Beilstein J. Nanotechnol. 2022, 13, 807–816, doi:10.3762/bjnano.13.71

• between the plant surface and insect adhesive devices [16][18], and absorption of the insect adhesive fluid [19]. Whereas the upper wax platelets are rather fragile and can be easily broken into small pieces and removed from the slippery zone thus contaminating insect attachment organs, the pitchers still

Polarity in cuticular ridge development and insect attachment on leaf surfaces of Schismatoglottis calyptrata (Araceae)

• Venkata A. Surapaneni,
• Tobias Aust,
• Thomas Speck and
• Marc Thielen

Beilstein J. Nanotechnol. 2021, 12, 1326–1338, doi:10.3762/bjnano.12.98

• been demonstrated to influence insect attachment [23]. Our experiments showed reduced traction forces of the model insects (female L. decemlineata, Coleoptera) on freshly unrolled and adult S. calyptrata adaxial leaf surfaces. The reduction in the traction forces of the beetles was almost 83% on the

• cuticular structure (ridge) development and might, thus, be of interest with regard to bioinspired applications. While the macroscale morphology of the leaves is expected to influence insect attachment during young leaf stages, the cuticular microstructuring on the leaf surfaces influences insect attachment

A comparison of tarsal morphology and traction force in the two burying beetles Nicrophorus nepalensis and Nicrophorus vespilloides (Coleoptera, Silphidae)

• Liesa Schnee,
• Benjamin Sampalla,
• Josef K. Müller and
• Oliver Betz

Beilstein J. Nanotechnol. 2019, 10, 47–61, doi:10.3762/bjnano.10.5

• clues concerning the mechanisms behind insect attachment. Although burying beetles appear not to be especially adapted to smooth and slippery plant surfaces, N. nepalensis is known as a ‘good climber’ [2] and both the investigated species exhibit, like other burying beetles [8], many tarsal adhesive

• differences in insect attachment performance between closely related species. Our results suggest that, on smooth surfaces, even subtle differences in the adhesion-mediating secretion might be responsible for the observed general difference between the two species in their ability to attach to smooth surfaces

• condition of removed claws, i.e., only the adhesive setae are considered. In other insect attachment experiments, the highest forces without claws were in general reached on smooth surfaces compared with any kind of structured surface [14][16]. In our case, this held true for N. nepalensis only, whereas N

Surfactant-induced enhancement of droplet adhesion in superhydrophobic soybean (Glycine max L.) leaves

• Oliver Hagedorn,
• Ingo Fleute-Schlachter,
• Hans Georg Mainx,
• Viktoria Zeisler-Diehl and
• Kerstin Koch

Beilstein J. Nanotechnol. 2017, 8, 2345–2356, doi:10.3762/bjnano.8.234

• mechanical stability [5]. Furthermore, the cuticle interacts with its biotic environment and plays a crucial role for insect signaling [6] and insect attachment [7][8][9]. The leaf surfaces are composed of epidermis cells covered by a cuticle, which is a continuous extracellular membrane on primary plant

Structural and tribometric characterization of biomimetically inspired synthetic "insect adhesives"

• Matthias W. Speidel,
• Malte Kleemeier,
• Andreas Hartwig,
• Klaus Rischka,
• Angelika Ellermann,
• Rolf Daniels and
• Oliver Betz

Beilstein J. Nanotechnol. 2017, 8, 45–63, doi:10.3762/bjnano.8.6

• of emulsions appears over-large in terms of the necessity to create reversible attachment structures mimicking insect attachment structures employed in locomotion (this holds true all the more, since we have tested the adhesive strength of the fluids between two rigid plates that show no distortion

Surface roughness rather than surface chemistry essentially affects insect adhesion

• Matt W. England,
• Tomoya Sato,
• Makoto Yagihashi,
• Atsushi Hozumi,
• Stanislav N. Gorb and
• Elena V. Gorb

Beilstein J. Nanotechnol. 2016, 7, 1471–1479, doi:10.3762/bjnano.7.139

• attachment of the beetles. Surface roughness was found to be the dominant factor, strongly affecting the attachment ability of the beetles. Keywords: insect attachment; superhydrophilicity; superhydrophobicity; superoleophobicity; surface structures; Introduction The development of functional coatings that

• to identify the most important parameters influencing insect attachment. Many insects, including beetles, can attach to inverted surfaces using specific hairy adhesive pads, covered with tenent setae, which secrete an adhesive fluid which typically consists of a mixture of alcohols, fatty acids, and

• hydrocarbons [26][27][28][29][30][31][32]. Several hypotheses exist on how plant surfaces prevent insect attachment. These are typically based on (1) the reduction of the contact area between the substrate and the insect adhesive pad through surface micro-roughness, (2) a decrease in substrate surface energy

Physical principles of fluid-mediated insect attachment - Shouldn’t insects slip?

• Jan-Henning Dirks

Beilstein J. Nanotechnol. 2014, 5, 1160–1166, doi:10.3762/bjnano.5.127

• -mediated attachment organs should minimize the secretion of adhesive fluid into the contact area to increase capillary adhesion on smooth surfaces. However, and this is where the simple “wet adhesion model” starts to fall short when used to model insect attachment, only very few natural surfaces are

Insect attachment on crystalline bioinspired wax surfaces formed by alkanes of varying chain lengths

• Elena Gorb,
• Sandro Böhm,
• Nadine Jacky,
• Louis-Philippe Maier,
• Kirstin Dening,
• Sasha Pechook,
• Boaz Pokroy and
• Stanislav Gorb

Beilstein J. Nanotechnol. 2014, 5, 1031–1041, doi:10.3762/bjnano.5.116

• experimental studies. The aim of this study was to examine the effect of different parameters of crystalline wax coverage on insect attachment. We performed traction experiments with the beetle Coccinella septempunctata and pull-off force measurements with artificial adhesive systems (tacky

• 30 fold, reduction of insect attachment forces on the wax surfaces when compared with the reference glass sample. Attachment of the beetles to the wax substrates probably relied solely on the performance of adhesive pads. We found no influence of the wax coatings on the subsequent attachment ability

• on wax samples when compared to insect attachment forces measured on these surfaces. We explain these results by the differences in material properties between polydimethylsiloxane probes and tenent setae of C. septempunctata beetles. Among wax surfaces, force experiments showed stronger insect

Impact of cell shape in hierarchically structured plant surfaces on the attachment of male Colorado potato beetles (Leptinotarsa decemlineata)

• Bettina Prüm,
• Robin Seidel,
• Holger Florian Bohn and
• Thomas Speck

Beilstein J. Nanotechnol. 2012, 3, 57–64, doi:10.3762/bjnano.3.7

• , leading to hierarchical surfaces if both levels are present. While it has been shown that epicuticular wax crystals and cuticular folds strongly reduce insect attachment, and that smooth papillate epidermal cells in petals improve the grip of pollinators, the impact of hierarchical surface structuring of

• plant surfaces possessing convex or papillate cells on insect attachment remains unclear. We performed traction experiments with male Colorado potato beetles on nine different plant surfaces with different structures. The selected plant surfaces showed epidermal cells with either tabular, convex or

• the hierarchical level of superimposed microstructuring, both wax crystals and cuticular folds have been shown to influence insect attachment strongly [7][8] and also the wettability of the surface [9][10]. Many plant surfaces possess hierarchical structuring but only a few of them have been analysed

The effect of surface anisotropy in the slippery zone of Nepenthes alata pitchers on beetle attachment

• Elena V. Gorb and
• Stanislav N. Gorb

Beilstein J. Nanotechnol. 2011, 2, 302–310, doi:10.3762/bjnano.2.35

• prominent lunate cells and displays continuous epicuticular crystalline wax coverage. The aim of this study was to examine the influence of the surface anisotropy, caused by the shape of lunate cells, on insect attachment ability. Traction tests with ladybird beetles Coccinella septempunctata were performed

• contributions, from claw interlocking and pad adhesion, to insect attachment on the pitcher surfaces, intact versus claw-ablated beetles were used in the second type of experiment. On both de-waxed plant samples and their replicas, intact insects generated much higher forces in the downward direction compared

• to the upward one, whereas clawless insects did not. These results led to the conclusion that, (i) due to the particular shape of lunate cells, the pitcher surface has anisotropic properties in terms of insect attachment, and (ii) claws were mainly responsible for attachment enhancement in the