Exfoliation of titanium nitride using a non-thermal plasma process

• Priscila Jussiane Zambiazi,
• Dolores Ribeiro Ricci Lazar,
• Larissa Otubo,
• Rodrigo Fernando Brambilla de Souza,
• Almir Oliveira Neto and
• Cecilia Chaves Guedes-Silva

Beilstein J. Nanotechnol. 2024, 15, 631–637, doi:10.3762/bjnano.15.53

• inherited from their parent crystals [6]. Their synthesis typically involves costly bottom-up processes. Some efforts have been successfully made to synthesize n-vdW 2D materials using liquid exfoliation techniques [7], albeit with relatively low yields. The first such material was obtained through

• electrostatically driven exfoliation of WO3 powder using bovine serum albumin as an exfoliating agent at pH 4 [8]. Subsequently, in 2018, Balan et al. [9] achieved the synthesis of hematene, a n-vdW 2D material, from natural iron ore hematite (α-Fe2O3) using liquid exfoliation. Unlike hematite, hematene exhibited

• conductivity [10][11][12]. On the nanoscale, TiN finds applications as additive in titanium alloys, as catalyst support material, as supercapacitor component, and as nanocoating for medical implants [13][14][15][16]. Furthermore, ultra-small TiN nanodots have been successfully obtained through liquid

Liquid phase exfoliation of talc: effect of the medium on flake size and shape

• Samuel M. Sousa,
• Helane L. O. Morais,
• Joyce C. C. Santos,
• Ana Paula M. Barboza,
• Bernardo R. A. Neves,
• Elisângela S. Pinto and
• Mariana C. Prado

Beilstein J. Nanotechnol. 2023, 14, 68–78, doi:10.3762/bjnano.14.8

• boiling point, butanone leaves less residues when exfoliated flakes are deposited onto substrates for atomic force microscopy (AFM) measurements. Table 1 summarizes the solutions tested here, and details of the sample preparation can be found in the Experimental section. Liquid exfoliation of talc Talc

• most symmetrical are those of butanone and Triton X-100. All comparisons can be found in Table 3. Finally, let us analyze advantages and drawbacks of each sample. An aqueous solution of 6 mg/mL sodium cholate is a widely recommended medium for liquid exfoliation [6][11]. For talc, it does yield the

• graphite monochromator using Cu Kα radiation (1.54056 Å) in the Bragg–Brentano geometry (θ/2θ). Talc liquid-phase exfoliation. Before submitting the material to the liquid exfoliation process, a purification step was performed to remove any contaminations [11]. Talc powder was sonicated for 1 h in

Efficient liquid exfoliation of KP₁₅ nanowires aided by Hansen's empirical theory

• Zhaoxuan Huang,
• Zhikang Jiang,
• Nan Tian,
• Disheng Yao,
• Fei Long,
• Yanhan Yang and
• Danmin Liu

Beilstein J. Nanotechnol. 2022, 13, 788–795, doi:10.3762/bjnano.13.69

• temperature measurements of KP15 nanodevices. Keywords: Hansen's empirical theory; KP15; liquid exfoliation; nanodevices; nanowires; Raman; semiconductors; Introduction Low-dimensional materials have drawn significant attention in recent years. So far, not only new composite materials with excellent

• -red KP15 bulks were finally obtained. Liquid exfoliation For the liquid-exfoliation process, 1 mg of KP15 was mixed in 20 mL of solvent and ultrasonically processed at a power of 80 W in an ice bath for 6 h, followed by centrifugation at 2000 rpm for 20 min. For the samples with predetermined

• coefficient and the Hansen solubility parameters for KP15 According to the Hansen’s theory [19], the dispersed concentration C of a KP15 dispersion prepared by liquid exfoliation can be expressed by Equation 1 as follows. where δD is the intermolecular dispersion force, δH is the intermolecular hydrogen bond

An implementation of spin–orbit coupling for band structure calculations with Gaussian basis sets: Two-dimensional topological crystals of Sb and Bi

• Sahar Pakdel,
• Mahdi Pourfath and
• J. J. Palacios

Beilstein J. Nanotechnol. 2018, 9, 1015–1023, doi:10.3762/bjnano.9.94

• those expectations closer to reality [33]. It was demonstrated that it is possible to isolate few or even single stable layers of antimonene, in ambient conditions. Moreover, new procedures such as liquid exfoliation and epitaxial growth methods were reported. Theoretical works on antimonene can be

Donor–acceptor graphene-based hybrid materials facilitating photo-induced electron-transfer reactions

• Anastasios Stergiou,
• Georgia Pagona and
• Nikos Tagmatarchis

Beilstein J. Nanotechnol. 2014, 5, 1580–1589, doi:10.3762/bjnano.5.170

• surfaces [5][6], liquid exfoliation via sonication [7][8], dissolution in superacids such as chlorosulfonic acid [9] and ball milling [10]. However, a major drawback of graphene, likewise of carbon nanotubes, stems from its insolubility in all solvents, which impedes the chemical manipulation toward