Ultrastructural changes in methicillin-resistant Staphylococcus aureus induced by positively charged silver nanoparticles

• Dulce G. Romero-Urbina,
• Humberto H. Lara,
• J. Jesús Velázquez-Salazar,
• M. Josefina Arellano-Jiménez,
• Eduardo Larios,
• Anand Srinivasan,
• Jose L. Lopez-Ribot and
• Miguel José Yacamán

Beilstein J. Nanotechnol. 2015, 6, 2396–2405, doi:10.3762/bjnano.6.246

• , microwave irradiation generated thermal energy that was able to convert silver nitrate into metallic silver. In such a manner, we are able to produce silver nanoparticles in water without the introduction of contaminants and toxic chemicals, such as borohydride or chloride. Determination of particle size

Green and energy-efficient methods for the production of metallic nanoparticles

• Mitra Naghdi,
• Mehrdad Taheran,
• Satinder K. Brar,
• M. Verma,
• R. Y. Surampalli and
• J. R. Valero

Beilstein J. Nanotechnol. 2015, 6, 2354–2376, doi:10.3762/bjnano.6.243

• the role of reducers, stabilizers or solvents. Also, there are some reports on using ultraviolet (UV), gamma and microwave irradiation that are capable of reducing and provide uniform heating. According to the literature, it is possible to use green reagents and novel energy transfer techniques for

• logically controlled by using polymers as soft support [21]. Using microwave irradiation can reduce energy requirement and provides a more environmentally friendly approach in comparison to conventional methods. Furthermore, microwave irradiation provides uniform nucleation and growth conditions for

• L-lysine or L-arginine, and stabilized it with soluble starch. In comparison to Lai et al. they reduced the energy requirement using microwave irradiation for 10 s at 150 °C. According to the TEM micrographs, the average particle size of the produced Ag NPs was 26.3 nm. They found that increasing

Fabrication of hybrid graphene oxide/polyelectrolyte capsules by means of layer-by-layer assembly on erythrocyte cell templates

• Joseba Irigoyen,
• Nikolaos Politakos,
• Eleftheria Diamanti,
• Elena Rojas,
• Marco Marradi,
• Raquel Ledezma,
• Layza Arizmendi,
• J. Alberto Rodríguez,
• Ronald F. Ziolo and
• Sergio E. Moya

Beilstein J. Nanotechnol. 2015, 6, 2310–2318, doi:10.3762/bjnano.6.237

• washed to neutral pH. Following this, we washed with dilute HCl followed again by water washes to neutral pH. The graphene oxide was exfoliated via ultra-sonication and microwave irradiation. FTIR spectra were taken with a Nexus 470 Spectrometer over 4000–400 cm−1 using multiple scans and 4 cm−1

Transformation of hydrogen titanate nanoribbons to TiO₂ nanoribbons and the influence of the transformation strategies on the photocatalytic performance

• Melita Rutar,
• Nejc Rozman,
• Matej Pregelj,
• Carla Bittencourt,
• Romana Cerc Korošec,
• Andrijana Sever Škapin,
• Aleš Mrzel,
• Srečo D. Škapin and
• Polona Umek

Beilstein J. Nanotechnol. 2015, 6, 831–844, doi:10.3762/bjnano.6.86

• the calcined TiO2 NRs (TO-650) with the XRD patterns of the hydrothermally derived TiO2 NRs (CH-W) and the sample produced under microwave irradiation (MW-W) shows a lower crystallinity in the latter two cases. The additional annealing of CH-W and MW-W in the NH3(g)Ar(g) flow and air, respectively

Microwave assisted synthesis and characterisation of a zinc oxide/tobacco mosaic virus hybrid material. An active hybrid semiconductor in a field-effect transistor device

• Shawn Sanctis,
• Rudolf C. Hoffmann,
• Sabine Eiben and
• Jörg J. Schneider

Beilstein J. Nanotechnol. 2015, 6, 785–791, doi:10.3762/bjnano.6.81

• HRTEM investigations of the as-synthesized particles formed from the precursor solution, which yield stable zinc oxide nanoparticles (Figure 2a). TEM also indicates the successful formation of ZnO nanocrystals in solution after the completion of the microwave irradiation process. Grazing incidence X-ray

• the ZnO nanoparticles within the deposited ZnO film [21][22]. In order to perform an in situ microwave-based mineralization of the TMV, it is essential to ensure that the virus particle adheres to the substrate during the microwave irradiation. Intense microwave irradiations are known to have a strong

• tendency to denature proteins and cause potentials damage to its structural integrity [23]. Additionally, prolonged high-power microwave irradiation could lead to unexpected heating of the substrate onto which the TMV are immobilized. The substrates with the docked virus were thus immersed in a control

Structural, optical, opto-thermal and thermal properties of ZnS–PVA nanofluids synthesized through a radiolytic approach

• Alireza Kharazmi,
• Nastaran Faraji,
• Roslina Mat Hussin,
• Elias Saion,
• W. Mahmood Mat Yunus and
• Kasra Behzad

Beilstein J. Nanotechnol. 2015, 6, 529–536, doi:10.3762/bjnano.6.55

• be a good choice for preparing colloidal suspensions due to its significant advantageous such as processability and high transmittance [8]. Various physical and chemical routes have been used to synthesize these nanocomposites such as microwave irradiation [9], chemical synthesis [10], sputtering [11

Protein-coated pH-responsive gold nanoparticles: Microwave-assisted synthesis and surface charge-dependent anticancer activity

• Dickson Joseph,
• Nisha Tyagi,
• Christian Geckeler and
• Kurt E.Geckeler

Beilstein J. Nanotechnol. 2014, 5, 1452–1462, doi:10.3762/bjnano.5.158

• biomedicine. Eight different proteins were examined in the preparation of gold nanoparticles (AuNPs) in aqueous medium under microwave irradiation. Six of the proteins resulted in the formation of AuNPs. The intrinsic pH of the proteins played an important role in AuNPs with strong surface plasmon bands. The

• differences in molecular weights, isoelectric points (IEP), and functions for the preparation of AuNPs. The AuNPs were prepared by using a one-pot green synthetic protocol assisted by microwave irradiation in the presence of proteins in aqueous media. Because proteins with different IEPs have been utilized

• observed a red color that is characteristic for the formation of AuNPs. Several experiments were carried out by varying the thermal conditions but the AuNP formation took several hours. Hence, we used microwave irradiation with an aim to reduce the reaction time, as it is known to accelerate chemical

Chemi- vs physisorption in the radical functionalization of single-walled carbon nanotubes under microwaves

• Victor Mamane,
• Guillaume Mercier,
• Junidah Abdul Shukor,
• Jérôme Gleize,
• Aziz Azizan,
• Yves Fort and
• Brigitte Vigolo

Beilstein J. Nanotechnol. 2014, 5, 537–545, doi:10.3762/bjnano.5.63

• minutes by using microwave-induced heating [7] as shown by the increasing number of publications in the past years [8]. Microwave irradiation has been efficiently used to assist CNT functionalization by cycloaddition [9][10][11][12][13][14], aryl radical addition [15][16][17][18], oxidation [19

Twofold role of calcined hydrotalcites in the degradation of methyl parathion pesticide

• Alvaro Sampieri,
• Geolar Fetter,
• María Elena Villafuerte-Castrejon,
• Adriana Tejeda-Cruz and
• Pedro Bosch

Beilstein J. Nanotechnol. 2011, 2, 99–103, doi:10.3762/bjnano.2.11

• , ultrasound or microwave irradiation, among others) determine the properties of the HT-like compounds [9][10][11][12][13][14][15][16][17]. HTs are versatile lamellar compounds which may exchange anions. Carbonates are always preferred and it is difficult to inhibit the formation of carbonated HTs [18][19

Enhanced visible light photocatalysis through fast crystallization of zinc oxide nanorods

• Sunandan Baruah,
• Mohammad Abbas Mahmood,
• Myo Tay Zar Myint,
• Tanujjal Bora and
• Joydeep Dutta

Beilstein J. Nanotechnol. 2010, 1, 14–20, doi:10.3762/bjnano.1.3

• microwave irradiation) have already been reported in a previous publication [20]. A higher optical absorption in the visible region was observed in this case. The faster degradation of methylene blue (MB) in the presence of nonstoichiometric crystallites of ZnO prepared through fast crystallization can be

• using microwave irradiation. Results and Discussion The ZnO nanoparticles obtained through the sol–gel synthesis (see section Experimental) are shown in Figure 1a and Figure 1b as transmission electron microscopy (TEM) micrographs. The low-resolution TEM micrograph exhibits spherical nanoparticles with

• crystallization (with microwave irradiation) is shown in Figure 4. The width and length of the nanorods were measured after 5 h growth with starting solutions of 0.1 mM, 1.0 mM and 10.0 mM zinc nitrate hexahydrate and hexamethylenetetramine at a temperature of 90 °C. An increase in size was observed for the