Facile synthesis of size-tunable L-carnosine-capped silver nanoparticles and their role in metal ion sensing and catalytic degradation of p-nitrophenol

• Akash Kumar,
• Ridhima Chadha,
• Abhishek Das,
• Nandita Maiti and
• Rayavarapu Raja Gopal

Beilstein J. Nanotechnol. 2024, 15, 1576–1592, doi:10.3762/bjnano.15.124

• degradation of P-NP by ʟ-car-AgNPs can be attributed to the unique optical and catalytic properties of AgNPs, which are enhanced by their high surface-to-volume ratio and plasmonic effects. The observed pseudo-first-order kinetics suggest that the rate-determining step involves the adsorption of P-NP onto the

A visible-light photodetector based on heterojunctions between CuO nanoparticles and ZnO nanorods

• Doan Nhat Giang,
• Nhat Minh Nguyen,
• Duc Anh Ngo,
• Thanh Trang Tran,
• Le Thai Duy,
• Cong Khanh Tran,
• Thi Thanh Van Tran,
• Phan Phuong Ha La and
• Vinh Quang Dang

Beilstein J. Nanotechnol. 2023, 14, 1018–1027, doi:10.3762/bjnano.14.84

• properties of ZnO nanostructures, such as bandgap or conductivity [26]. Decorating ZnO with metals such as Ag, Au, Pd, Pt, and Al [27][28] can provide surface plasmonic effects that assist the electron transfer process in materials and extend the light absorption range of a photodetector [29][30]. However

A set of empirical equations describing the observed colours of metal–anodic aluminium oxide–Al nanostructures

• Cristina V. Manzano,
• Jakob J. Schwiedrzik,
• Gerhard Bürki,
• Laszlo Pethö,
• Johann Michler and
• Laetitia Philippe

Beilstein J. Nanotechnol. 2020, 11, 798–806, doi:10.3762/bjnano.11.64

• (AAO) films; anodization; structural colours; reflectance; polar coordinates; plasmonic effects; Introduction Recently, the reproduction of the vivid colours found in nature has received increasing interest [1]. These colours appear when light interacts with periodic structures. With regard to this

• observed before [18][19]. In both cases, after the deposition of 8 nm of Cr and 10 nm of Au on top of the AAO–Al films (Figure 2b and Figure 2c, respectively), a blueshift and a decrease in the reflectance is observed due to plasmonic effects [4][11][13]. The wavelength of each sample and consequently the

• used in order to obtain different colours of the metal–AAO–Al nanostructures due the different plasmonic effects in both metals. In addition, three different metal thicknesses were studied (25, 17.5 and 10 nm of Au) to show the influence of metal thickness on the observed colour. It is important to

Quantification and coupling of the electromagnetic and chemical contributions in surface-enhanced Raman scattering

• Yarong Su,
• Yuanzhen Shi,
• Ping Wang,
• Jinglei Du,
• Markus B. Raschke and
• Lin Pang

Beilstein J. Nanotechnol. 2019, 10, 549–556, doi:10.3762/bjnano.10.56

• range of Raman modes studied, we can neglect spectral variations of the electromagnetic field enhancement, e.g., due to plasmonic effects, and assume that the electromagnetic enhancement is the same for all modes. The relative enhancement will then reflect the variations of CE for the different modes

Au–Si plasmonic platforms: synthesis, structure and FDTD simulations

• Anna Gapska,
• Marcin Łapiński,
• Paweł Syty,
• Wojciech Sadowski,
• Józef E. Sienkiewicz and
• Barbara Kościelska

Beilstein J. Nanotechnol. 2018, 9, 2599–2608, doi:10.3762/bjnano.9.241

• . Of course, this increase was closely related to the development of novel manufacturing technologies. One of the most interesting fields based on metal nanostructures is plasmonics. The use of plasmonic effects opens up many interesting possibilities, as for example photoluminescence intensification

Mechanistic insights into plasmonic photocatalysts in utilizing visible light

• Kah Hon Leong,
• Azrina Abd Aziz,
• Lan Ching Sim,
• Pichiah Saravanan,
• Min Jang and
• Detlef Bahnemann

Beilstein J. Nanotechnol. 2018, 9, 628–648, doi:10.3762/bjnano.9.59

• . This formation is a result of notable contact between noble metal nanoparticles with a semiconductor. Plasmonic effects have been verified to increase the photocatalytic performance due to the intrinsic influences on the semiconductor photocatalyst. Plasmonic effects work to improve harvesting of

• the surface of TiO2 [106]. More detailed work needs to be carried out to identify the individual contributions from different plasmonic effects such as hot-electron injection, generation of electromagnetic field and plasmon-induced heating [107]. The measurement of plasmonic photoelectrodes with

Optical response of heterogeneous polymer layers containing silver nanostructures

• Miriam Carlberg,
• Florent Pourcin,
• Olivier Margeat,
• Judikaël Le Rouzo,
• Gérard Berginc,
• Rose-Marie Sauvage,
• Jörg Ackermann and
• Ludovic Escoubas

Beilstein J. Nanotechnol. 2017, 8, 1065–1072, doi:10.3762/bjnano.8.108

• energy, and B and C are two constants. The extinction coefficient of the host matrix is zero in the visible wavelength range, i.e., the absorption of the heterogeneous thin films will be only due to plasmonic effects. The parameters for the Cauchy law are listed in Table 1. The measured refractive

Graphene-enhanced plasmonic nanohole arrays for environmental sensing in aqueous samples

• Christa Genslein,
• Peter Hausler,
• Eva-Maria Kirchner,
• Rudolf Bierl,
• Antje J. Baeumner and
• Thomas Hirsch

Beilstein J. Nanotechnol. 2016, 7, 1564–1573, doi:10.3762/bjnano.7.150

• baseline was again obtained. That means that no specific binding between sample components and the graphene layer was formed. Thus, synergistic plasmonic effects caused by the interplay of the localized surface plasmons with the plasmonics of the overlaid carbon nanostructures lead to the significant

Fabrication and properties of luminescence polymer composites with erbium/ytterbium oxides and gold nanoparticles

• Julia A. Burunkova,
• Ihor Yu. Denisiuk,
• Dmitri I. Zhuk,
• Lajos Daroczi,
• Attila Csik,
• István Csarnovics and
• Sándor Kokenyesi

Beilstein J. Nanotechnol. 2016, 7, 630–636, doi:10.3762/bjnano.7.55

• realization of plasmonic effects in such a nanocomposite was also aimed and successfully performed. This can be further used as continuation of our previous work on the investigations of polymer nanocomposites for photonics [9][10][11]. Results and Discussion Investigations of rare-earth oxide nanoparticles

Hollow plasmonic antennas for broadband SERS spectroscopy

• Gabriele C. Messina,
• Mario Malerba,
• Pierfrancesco Zilio,
• Ermanno Miele,
• Michele Dipalo,
• Lorenzo Ferrara and
• Francesco De Angelis

Beilstein J. Nanotechnol. 2015, 6, 492–498, doi:10.3762/bjnano.6.50

• has become an important factor for the routine application of this technique to biology. There has been a significant increase in the number of studies concerning applications based on plasmonic effects in recent years. The areas of interest range from biomedicine, with examples of biosensing devices

Tunable light filtering by a Bragg mirror/heavily doped semiconducting nanocrystal composite

• Ilka Kriegel and
• Francesco Scotognella

Beilstein J. Nanotechnol. 2015, 6, 193–200, doi:10.3762/bjnano.6.18

• voltage to conducting films of metal oxide NCs [33]. In a recent study, the modulation of transmittance was electrochemically achieved in layers of transparent conducting NCs, such as ITO [34][35][36]. Moreover, plasmonic effects have been exploited for electrochromic applications for the direct

Exploring plasmonic coupling in hole-cap arrays

• Thomas M. Schmidt,
• Maj Frederiksen,
• Vladimir Bochenkov and
• Duncan S. Sutherland

Beilstein J. Nanotechnol. 2015, 6, 1–10, doi:10.3762/bjnano.6.1

• attracted interest by combining simple production [8] and both unique properties such as bending of light [9] resulting from reduced symmetry compared to nanoshells and other more common plasmonic effects such as enhanced local electromagnetic fields [8]. Another related plasmonic structure of interest

Low-cost plasmonic solar cells prepared by chemical spray pyrolysis

• Erki Kärber,
• Atanas Katerski,
• Ilona Oja Acik,
• Valdek Mikli,
• Arvo Mere,
• Ilmo Sildos and
• Malle Krunks

Beilstein J. Nanotechnol. 2014, 5, 2398–2402, doi:10.3762/bjnano.5.249

• the smaller absorbing volume. The use of mesoporous TiO2 or ZnO nanorods provides increased surface area of the absorber, while the introduction of metal nanoparticles allows photons to be captured via plasmonic effects [1][2][3][4]. This work attempts to utilize the advantages of the plasmon effect

• photocurrent due to the plasmonic effects of NPs have been demonstrated, for example, for thin film Si solar cells [3], polymer cells [10][11], dye-sensitized cells [12][13] and for solar cells that use ultrathin inorganic absorber layers [14]. However, the use of an in-line spray method for the deposition of

Challenges in realizing ultraflat materials surfaces

• Takashi Yatsui,
• Wataru Nomura,
• Fabrice Stehlin,
• Olivier Soppera,
• Makoto Naruse and
• Motoichi Ohtsu

Beilstein J. Nanotechnol. 2013, 4, 875–885, doi:10.3762/bjnano.4.99

• the bottom of the grooves (arrows in Figure 4f and Figure 4h) disappeared. TiO2 was transparent to the incident light, so the coherent oscillation of electrons over its periodic structure was negligible. Therefore, plasmonic effects, which can sometimes originate from periodic enhancement of the local