Gold nanomakura: nanoarchitectonics and their photothermal response in association with carrageenan hydrogels

• Nabojit Das,
• Vikas,
• Akash Kumar,
• Sanjeev Soni and
• Raja Gopal Rayavarapu

Beilstein J. Nanotechnol. 2024, 15, 678–693, doi:10.3762/bjnano.15.56

• DTAB-AuNM, respectively. Growth mechanism of gold nanomakura particles (AuNM). (a) AuNM surrounded by surfactant micelles; (b) growth facet of AuNM; and (c) stepwise growth mechanism during AuNM formation. (a) Seed-mediated synthesis of CTAB-capped AuNR. (b) Seedless synthesis of DTAB-capped AuNR. (c

Laser synthesis of nanoparticles in organic solvents – products, reactions, and perspectives

• Theo Fromme,
• Sven Reichenberger,
• Katharine M. Tibbetts and
• Stephan Barcikowski

Beilstein J. Nanotechnol. 2024, 15, 638–663, doi:10.3762/bjnano.15.54

• colloidal Pt solution [138]. The chemical processes leading to the formation of polyynes are still not fully understood, but a few models have been proposed over the years. Tsuji et al. proposed a model for ns-LAL. They suggested a stepwise growth of hydrogen-capped polyynes by the addition of carbon

Properties of tin oxide films grown by atomic layer deposition from tin tetraiodide and ozone

• Kristjan Kalam,
• Peeter Ritslaid,
• Tanel Käämbre,
• Aile Tamm and
• Kaupo Kukli

Beilstein J. Nanotechnol. 2023, 14, 1085–1092, doi:10.3762/bjnano.14.89

• experiments. Concurrently with the determination of the film thickness via ex situ measurements, the film growth upon cycling precursor pulses and purge periods was monitored in real time. The in situ monitoring helped in the visualization of the stepwise growth process (Figure 2). One can see that the

Coating of upconversion nanoparticles with silica nanoshells of 5–250 nm thickness

• Cynthia Kembuan,
• Maysoon Saleh,
• Bastian Rühle,
• Ute Resch-Genger and
• Christina Graf

Beilstein J. Nanotechnol. 2019, 10, 2410–2421, doi:10.3762/bjnano.10.231

• followed by a stepwise growth of these particles without a purification step, where in each step equal volumes of tetraethyl orthosilicate and ammonia water are added, while the volumes of cyclohexane and the surfactant Igepal® CO-520 are increased so that the ammonia water and surfactant concentrations

• stepwise growth, falls below −40 mV, the particles can be dispersed in an ammoniacal ethanol solution and grown further by the continuous addition of tetraethyl orthosilicate to a diameter larger than 500 nm. Due to the high colloidal stability, a coalescence of the particles can be suppressed, and single

• -core particles are obtained. This strategy can be easily transferred to other nanomaterials for the design of plasmonic nanoconstructs and sensor systems. Keywords: reverse microemulsion; silica coating; stepwise growth; thick shells; upconversion nanoparticles; Introduction Lanthanide-based